You have no items in your shopping cart.
Hose
ProFlex Hose
ProFlex Hose; -10AN; 3 ft. Roll; Actual ID 9/16 in.; Nominal ID 5/8 in.; OD 25/32 in.; Max psi 750;
- Color: Silver
- Inside Diameter: 0.5625 in.
- Material: Braided Stainless Steel
- Outside Diameter: 0.7813 in.
- Product Length: 3 ft.
- Size: -10AN - 0.625 in.
- WARNING CA Proposition 65: Yes
- WARNING CA Proposition 65 Message: WARNING: This product can expose you to Lead; which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information; visit www.P65warnings.ca.gov.
- Stainless Steel Covering For A More Attractive Installation
- Stainless Steel Covering Is Abrasion Resistant
- Temp. Range of -40 Deg. F to +350 Deg. F For Many Uses
- Compatible w/Hydrocarbon/Alcohol-Based Fuels/Lubricants/Additives
- Available In A Wide Range of AN Sizes To Meet Your Needs
- Choice of Full Flow/NonSwivel/Swivel/ProClassic CrimpOn Hose Ends
- Approved By NHRA For Use In Competition
These Hoses are constructed with a stainless steel outer braid that resists abrasion and corrosion, both have a Chlorinated Polyethylene (CPE) synthetic rubber liner with a nylon inner braid that will not collapse under extreme heat, yet is extremely flexible. Superior ProRace hose has the same features as ProFlex but with a specially formulated CPE synthetic inner liner that is embedded with a partial coverage stainless steel inner braid, then bonded together by a full coverage stainless outer braid for 50% more strength.
Edelbrock Corporation has six locations: four in Torrance and two in San Jacinto, California, totaling over 600,000 square feet. Headquarters include: R&D; manufacturing; tech support and more. Less than a mile away the Exhaust and Suspension Division design and manufacture high quality components using custom built equipment and state-of-the-art testing facilities. Our Aluminum Foundry and Motorcycle Division, where we manufacture carburetors for motorcycles, is located in San Jacinto. Our sand-cast foundry has been called "the most state-of-the-art foundry west of the Mississippi." In 2007 we will be adding a new Permanent Mold and Heat Treat facility next to our existing sand cast foundry, an over 8 million dollar commitment to "Made in USA" products and performance. In October 1999, we moved our warehouse into a new Distribution Center. All shipping and receiving operations were relocated to provide room for the expansion of our cylinder head, water pump and manifold manufacturing area at the main facility. Vic's Garage is located in the Distribution Center and houses the Company's collection of street rods and classic cars, as well as our extensive collection of historic photos and archives. Please call and make an appointment if you would like to tour Vic's Garage. Russell Performance Products became part of the Edelbrock family early in 2001. They were moved to the shock facility in the spring and we are pleased to welcome the Russell employees to "The Fun Team." Into the Future, "Proven Performance" is the philosophy that began with Vic Sr. in 1938 and it continues today with the same high standards of performance and quality. Vic Sr. would be proud of what has grown out of his small garage in Los Angeles, California.